Hilti TE 3000-AVR Mode D'emploi page 24

Vibration information
Chiseling (a )
h, Cheq
Uncertainty (K)
4.2 Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Information on recommended minimum conductor cross-sections and cable lengths is accessible via a link,
in the form of a QR code, at the end of this document.
5 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Accessory tool 3
For this product, use only Hilti chisels with the TE-H connection end.
Other chisels cannot be engaged correctly in the chuck and the yellow warning ring on the tool lock
remains visible. It indicates that the accessory tool is not suitable for the breaker!
▶ Before each use, check that the yellow warning ring on the tool lock is no longer visible.
5.2 Inserting the accessory tool
Check the accessory tool for damage or uneven wear each time before use and replace it if necessary.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the chisel with the TE-H connection end into the tool holder until it engages with an audible click
and the yellow warning ring is no longer visible.
3. Check that the chisel has engaged correctly by gripping and pulling it.
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage
to the product.
18 English
4
TE 3000­AVR
6.3 m/s²
1.5 m/s²
2228667
*2228667*