Uline METRO Serie Instructions D'installation page 5

Steel Foot x 1
Laminate Panel x 3
NOTE: If add-on divider is purchased, it will be
connected to one of the starter divider's posts.
1. Position the starter divider in the desired end
location before connecting the add-on divider.
2. Decide which direction the add-on divider will stem
from the starter divider. The posts have a four-way
connection to create straight walls and corners.
(See Figure 8)
3. Repeat steps 1-8 to assemble the add-on divider
and connect it to the starter divider using one of
the posts.
NOTE: Add-on dividers include an adjustable
leveling glide that can be used in place of a
steel foot in the center.
4. If additional add-on dividers will be connected,
repeat steps 1-8 for each add-on divider.
PAGE 5 OF 15
ADD-ON DIVIDER PARTS
Post x 1
Acrylic Panel x 2
ADD-ON DIVIDERS ASSEMBLY
1-800-295-5510
uline.com
Horizontal Bar with Locks x 3
B
A
Bolt x 4
Post Cap x 1
Figure 8
Vertical Bar with Locks
x 3
C
Bolt Cover x 12
1122 IH-10314