Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE AND CLEANING
Maintenance
If the air filter is dirty or clogged it can affect the operation of the product. We recommend
maintaining and/or replacing the filter every 2 weeks.
G.
1.
Remove the air vent on the back of the product as shown in Figure G.
2. Carefully remove the air filter and holder as shown in Figure H.
3. Clean the filter with a vacuum cleaner to make it dust-free.
4. If the filter is very dirty you can wash it with water and a mild detergent. Do not use abrasive
or harsh detergents.
5. Rinse the filter well and let it dry.
Cleaning
Clean the casing of the product with a soft, clean cloth. If it is very dirty, you can clean it with
a slightly damp cloth. Do not use abrasive or harsh cleaning agents. Never use a wet cloth to
clean the product.
Remove the water tank and clean the inside with clean water. If you clean it with an abrasive
sponge or brush, it may cause scratches. Never remove the float inside the water tank. Clean
the outside with a cloth. After cleaning, replace the water tank properly.
Storage
Store the product in a dry, clean place. Do not store the product in extremely high or low tem-
peratures.
If the product is not going to be used for a long time:
1.
Unplug and secure the plug at the back of the product.
2. Empty the water tank and make sure it is clean and dry.
3. Clean the air filter.
4. Make sure the product is stored upright and avoid direct sunlight.
32
TROUBLESHOOTING
Problem
H.
The product is not
working.
The product does not
dehumidify properly.
The product makes noise
during operation.
The product suddenly
stops dehumidifying.
Cause
Solution
Make sure the plug is plugged in
The plug is not plugged in.
correctly.
The water tank is full.
Make sure the water tank is empty.
The water tank is not
Make sure the water tank is
inserted correctly.
correctly positioned in the product.
Make sure there is enough space
The air vents are blocked.
around the product. Make sure the
air vents are not blocked.
This is normal. See "Instructions for
The product is defrosting.
use > Defrosting".
Clean and maintain the air filter
The filter is dirty.
as described under "Maintenance
and cleaning".
Provide adequate space around
The air vents are blocked.
the product. Make sure the air
vents are not blocked.
Touch the position knob repeatedly
The product is not in
so that the dehumidify mode is
dehumidifying mode.
selected.
This is normal. The product stops
The temperature in the
when the temperature is below
room is too low.
5°C.
This is normal. The product stops
The humidity in the room
when the humidity is below 60%
is too low.
and is in automatic mode.
Make sure all windows and doors
are closed and that the room does
The room is too large.
not exceed the capacity of the
product. See "Product Features >
Technical data".
Always ensure that the product is
The product is not
installed on a flat, stable and level
installed correctly.
surface.
This is normal. The product will
The temperature in the
restart once the temperature has
room is higher than 35°C.
dropped.
English
33
Publicité
