Megasat Shipman Kompakt Mode D'emploi page 19

9. Mounting on the roof
13
The parts needed to install the roof outlet.
15
Position the roof outlet center behind the anten-
na (about 30 cm away). The open side of the roof
outlet must point toward the antenna. Then stick
the tape around at a distance of 4 mm.
17
Drag the cable (cable for the controller) through
the hole.
ENGLISH
16
All manuals and user guides at all-guides.com
14
Route the cable as shown here.
16
Drill a 15 mm hole centered inside the tag.
18
Place the roof outlet at the specified position and
drill the 3 holes (2 mm).
9. Mounting on the roof
19
Seal with special glue the edge of the roof outlet.
21
Cover now the screw heads with the special glue.
23
Remove the tape carefully and dry the special
glue.
25
Connect the power cable to the battery. Pay attention
to the correct polarization.
ENGLISH
20
Bolt the roof outlet with the M4 x 20 screws.
22
Smooth the glue joint.
24
Now connect the cables as described on page 7.
26
Connect the power supply cable to the control unit
and, if necessary, secure it to a wall.
17