Megasat Shipman Kompakt Mode D'emploi page 15

4. Operation and Usage
4.1 Operation while driving (Motion mode)
1. Switch on the control unit by pressing the power switch.
2. During the booting process (approx. 15-30 seconds), all satellite LEDs on the front of
the control unit light up.
3. After the control unit is ready for operation, the last used satellite is automatically
selected and searched for.
4. During the search for the satellite, the TRACKING LED lights up every time a satellite is
found. If it is not the one selected, the antenna will search further. This process takes
about 1-2 minutes.
5. Once the satellite is found, the LOCK LED will light.
4.2 Select another satellite
If you want to select another satellite, proceed as follows:
1. Press one of the arrow buttons on the front of the control unit until the LED of the
desired satellite lights up.
2. To confirm the satellite, press the SET button.
3. After the SET button is pressed, the new satellite is searched for.
4.3 Sleep mode
1. If the vehicle or antenna does not move for more than 1 minute, the system automati-
cally enters the sleep mode.
2. If you want to switch on the sleep mode manually, press the MODE button for 5 se-
conds. The LED of the current satellite is switched off and on again to show that the
sleep mode is active.
Note
Should you spend longer periods in a location, please deactivate the movement
mode (see point: 4.4 Operation at stationary location).
ENGLISH
08
All manuals and user guides at all-guides.com
4. Operation and Usage
4.4 Operation at stationary location
1. Make sure the control unit is switched off.
2. Hold down the MODE button and turn on the control unit (after approx. 5 seconds
you can release the MODE button.
3. During the booting process (about 15-30 seconds), all satellite LEDs and the mode
LED on the front of the control unit light up.
4. After the control unit is ready for operation, the last used satellite is automatically
selected and searched for.
5. The TRACKING LED will not light up in this mode.
6. Once the satellite is found, the LOCK LED will light.
4.5 Reset the antenna to the motion mode
If the system is in manual sleep mode and you want to return it to motion mode, pro-
ceed as follows:
1. Press the SET button for at least 5 seconds until the TRACKING and LOCK LEDs start
flashing.
2. Resetting the system takes about 3 seconds. The control unit restarts and returns to
the motion mode.
4.6 DiSEqC settings
You can set up your DiSEqC settings in your receiver. This has the advantage that the
antenna automatically aligns itself to another satellite. Change to the channel list of your
receiver, For example, from Astra to Hotbird, the antenna is self-directed to the satellite.
DiSEqC settings
LNB Satellite
1 Astra 2 (28,2° East)
2 Astra 1 (19,2° East)
3 Hotbird (13° East)
ENGLISH
Note
This function is only possible in stati-
onary operation (see point 4.4)!
09