Ford Perimeter Plus Guide De L'utilisateur page 8

Long-Range 1-Way and 2-Way Remote Start System (optional)
1-Way Transmitter
Starting Your Vehicle with the 1-Way Transmitter:
The remote start function is activated by pressing the
3 seconds on the 1-way remote control transmitter. The system will check the vehicle
to ensure that it is safe to start, and if all safety parameters are correct, the engine
will start within 5 seconds (diesel engines may take longer, to allow the glowplugs
sufficient time in all conditions to heat up).
Note: See the vehicle owner's manual for further details on remote start
operation.
Starting Your Vehicle with the 2-Way Transmitter:
The remote start function is activated by pressing the
3 seconds on the 2-way remote control transmitter. If you are within the operating
range of the system, your transmitter will respond with one single beep and one flash
of the blue LED above the
was received by the system. Once the vehicle starts (1-3 seconds later), your 2-way
transmitter will respond with 2 beeps and 2 flashes of the blue LED. While remote
started, the blue LED will continue to flash every few seconds indicating the vehicle
is still running via remote start.
Note: See the vehicle's owner manual for further remote start run time details.
Stopping Your Vehicle with the 1-Way and 2-wayTransmitter:
Press and hold** the
is shut down by any means (run time has expired, by remote control, gear shifter
actuated, hood opened), and you are within the operating range of the system, your
2-way transmitter (if equipped) will respond with 3 beeps and 3 flashes of the blue
LED, indicating the remote start system has turned off. If you are out of the system
operating range at the time of remote start shutdown, your 2-way transmitter (if
equipped) may keep flashing the blue LED up to 15 minutes after the remote start
was initiated or until vehicle is started by ignition key.
* May be activated by a "Press & Hold", refer to "User Selectable Options" in this manual.
** "Press & Hold" or "Pressing and Holding" refers to pushing the transmitter button for more
than 2.5 seconds.
8
Press two times to
activate Remote Start.
Press and hold**
manually shut down the
Remote Start.
button. This response indicates that the signal to start
button to turn off the vehicle. When the remote start
2-Way Transmitter
to
Press to initiate
Car Find. Press and
hold** to initiate Panic
button two times* within
button two times* within