Perimeter Plus Vehicle Security (optional)
When the Security System is Armed:
•All interior entry points are monitored for unauthorized entry (Note: depending
on trim level, the vehicle's hood or trunk / liftgate may not be monitored);
•The shock sensor (optional) monitors for impact to the vehicle's body or glass;
•The security LED indicator (optional) flashes once every few seconds.
If any monitored entry point is opened or hard impact is detected, the system will
activate an alarm cycle. During the alarm cycle:
•The horn sounds an on / off pattern;
•The front and rear lights flash;
•The security LED indicator (optional) begins to flash rapidly.
The alarm cycle (horn honks) lasts for 30 seconds (the front and rear lights may
continue to flash longer). At the end of the alarm cycle, the system will pause for
10 seconds and then begin monitoring for any further alarm conditions. If another
alarm condition is detected the system will go in to another alarm cycle.
Security LED Indicator (optional):
The optional security LED indicator is a high-intensity red light mounted in a visible
location on the vehicle dashboard. This red light gives a visual indication of the alarm
system's state of operation. Note the chart below:
If the Security LED is...
Off
Flashing slowly
Flashing quickly
On (not flashing)
Shock / Impact Sensor (optional):
While the security system is armed, the optional shock sensor monitors for impact
to both the vehicle's body and glass. If a light, not-threatening, impact is detected
the system will honk the horn and flash the exterior lights one (1) time to warn-away
would be intruders. In the event that a hard impact is detected, the system will trip an
alarm cycle. Increasing or decreasing sensitivity should be completed by a service
professional. If adjustment is necessary, please contact your local dealer.
Note: By design, the shock/impact sensor will not respond to vehicle motion/rocking
caused by wind or rocking vehicle with hands or feet. The sensor responds to near-
damaging or dammaging impact to vehicle surfaces.
Starter Interrupt (optional):
Starter Interrupt is an optional feature that can be installed on certain model vehicles.
If equipped, the starter is disabled any time the system is armed and starting of the
vehicle with an invalid ignition key is attempted.
...then the Security System is
Disarmed
Fully Armed
Triggered in your absence
In Pre-arm mode
5