Perimeter Plus Vehicle Security (optional)
NOTE:
Using your factory supplied Remote Keyless Entry (RKE) keyfob is the primary
method of arming and disarming your Perimeter Plus security system. The system is
armed when the doors are locked with the RKE keyfob. The system is disarmed when
the doors are unlocked with the RKE keyfob.
Arming the Security System:
The Vehicle Security System may be armed using any of the methods below.
1. By pressing the
2. Pressing the lock area on the door handle (intelligent access equipped vehicles
only).
3. By entering the "Lock" code into the keypad located on the outside of the driver's
door (if equipped).
The front and rear lights will flash and the security LED (optional) will illuminate for
10 - 20 seconds (pre-arm mode), after which the security system will arm. The security
LED will begin to "blink" and all closed entry points will be protected.
If an entry point is left open, the security system will continue to ignore that entry point
until it is closed.
Disarming the Security System:
The Vehicle Security System will be disarmed if any of the following actions are taken.
1. Pressing the
2. Touching the inside of the exterior door handle (intelligent access equipped
vehicles only).
3. Entering the "Unlock" code into the keypad located on the outside of the driver's
door (if equipped).
4. Turning the ignition "On" (must have a valid key read if equipped).
If there were no vehicle intrusion attempts while the security system was armed,
the security LED (optional) will turn off when the security system is disarmed. If any
vehicle intrusion attempts were made while the security system was armed, the
vehicle's horn will honk and the exterior lights will flash two (2) times and the security
LED (optional) will flash a fast on/off sequence indicating an intrusion attempt.
4
(Lock Button) on the factory RKE keyfob.
(Unlock Button) on the factory RKE keyfob.