Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
when installing hitch
Conical washer
teeth side
against hitch
Fasteners
typical
both sides
One Side (Typical)
Figure 2
1.
Lower Exhaust (Optional on Some Models): For ease of installation lowing the exhaust allows for more clearance to raise the hitch into place. Lower the exhaust hangers by using a
M12 socket to remove the (2) bolts from each exhaust hanger (4 bolts total, 2 per hanger). Be sure to support the exhaust before removing the bolts.
2.
Clean Weldnuts: Remove the sticker covering on the (2) weldnuts on the side of frame rails, both sides, see Figure 2. Use a M12x1.25 tap to clean the weldnuts if necessary.
3.
Install hitch: Raise the hitch into position and slide the brackets above the exhaust pipe. Align bracket holes to the frame rail weldnuts and loosely install M12 bolts (Item ①) and
conical washers (Item ②) to the hitch, see Figure 1. Due to narrow space around passenger side frame rails, use 18 mm crowfoot wrench to secure the M12 bolts on passenger side.
4.
Torque Bolts: Using a torque wrench with a 18 mm socket Tighten all M12 fastners torque wrench to 76 Ft.Lb. (103 N*M)
5.
Raise Exhaust: Raise exhaust back into place (if lowered in step 1)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
© 2023 Horizon Global™ Corp. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76634, 84634, CQT76634
①
②
Figure 1
Sheet 3 of 15
76634NP
Fastener Kit: 76634F
Qty. (4)
Bolt M12x1.25x30
CL8.8
Qty. (4)
Conical washer 1/2''
01-09-23
Rev. A
Publicité
