Thermador KBUIT4255E Instructions D'installation page 18

NOTE: Pass the dolly strap under the handles for the Curved
and Professional Series.
2. Place pieces of the shipping carton on the floor when rolling
the dolly and refrigerator into the house. Move the refrigerator
close to the built-in opening.
3. Place top of cardboard carton or plywood under refrigerator.
Remove dolly.
4. Do not remove film or cover.
5. \|f necessary, reassemble the trim and top grille after the dolly
has been removed from the refrigerator.
install Anti-Tip Boards
IMPORTANT:
gm To avoid tipping during use, the solid soffit must be within
" (2.5 cm) maximum above the refrigerator. If the solid soffit is
higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
gm l|tis recommended that board(s) be installed before the
refrigerator is installed.
m Board(s) must be long enough to fully cover the width of the
compressor cover.
m Locate the board(s) so the bottom surface(s) of the board(s)
is(are) 84" (213 cm) from the floor.
mg During installation, raise the refrigerator up so there is
Ya" (6.35 mm) maximum between the top of the refrigerator
and the bottom of the anti-tip board(s). Do not crush the
compressor cover when raising the rear leveling legs.
To Install Anti-tip Boards
1. Mark the stud locations on rear wall 80" to 90" (203 cm to
229 cm) above floor.
18
2. Securely attach one or two 2" x 4" x 32" (6cm x 10 cm x
81 cm) boards to wall studs behind refrigerator. Use six
#8 x 3" (7.6 cm) (or longer) wood screws. The wood screws
must be screwed into the studs at least 142" (3.8 cm). The
board(s) must overlap the compressor cover.
A. Center board 14" (6.35 mm) max. above refrigerator
B. Two 2" x 4" x 32" 6 cm x 10 cm x 81 cm) boards
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
Connect the Water Supply
Read all directions before you begin.
IMPORTANT: If you turn the refrigerator on before the water line is
connected, turn the ice maker OFF.
Connect to Water Line
Parts Needed:
mg Minimum 7 ft (2.13 m) flexible, codes approved water
supply line
Style 1 - Shutoff Valve Connection
NOTE: If your water line connection does not look like Style 1, see
"Style 2 - Copper Line Connection."
1. Unplug refrigerator or disconnect power supply.
IMPORTANT: Before attaching the tubing to shutoff valve, flush
the main water supply line to remove particles and air in the water
line. Allow enough flow so that water becomes clear. Flushing the
water line may help avoid filters and/or water valves from
becoming clogged.
2. Connect the flexible, codes approved water supply line to the
water shutoff valve by threading the provided nut onto the
shutoff valve as shown.
NOTE: The shutoff valve shown is in the side cabinet as
recommended.
A. Bulb
B. Nut
C. Water tubing