Hansgrohe AXOR Carlton 17001 Serie Mode D'emploi page 6

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin/bidet.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 8a) located behind the mousseur must
be removed.
To adjust the hot water limiter on single lever mixers,
please see page 12.
No adjustment is necessary when using a continuous
flow water heater.
6
English
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
Spare parts
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl. basin
5 service set
6 seals (5)
7 mixer ball
8 mousseur cpl. (10)
mousseur gold plated
mousseur fine brass
9 pull rod cpl.
9.1 pull knob
9.2 pull rod
10 fixation cpl.
11 connection hose
XXX = Colors
000 chrome plated
090 chrome plated/gold plated
120 chrome plated/porcelain colour
150 chrome plated/wood
810 satinox
840 fine brass
17091XXX
94063XXX
94130XXX
94106000
14095000
13952000
13962000
13964000
13085000
94980990
94980840
92620XXX
94066XXX
94067000
94138000
94071XXX
6