Publicité
Les langues disponibles
Les langues disponibles
Vandal Shield
Tools required:
•
Torx screwdriver T20
•
#2 Phillips screw driver
Tightening Torque
12-14 in-lbs
Figure 3.
1.
Loosen and remove the existing (4) 8-32 screws on the
face of the fixture (Figure 3).
2.
Align (4) 7/8" long spacers with existing holes (4).
3.
Use (4) 8-32 x 1-1/2" screws to secure vandal shield on
top of fixture.
4.
To remove vandal shield, follow steps 1-3 in reverse
order.
Installation Instructions – Galleon Wall Slim
Photocontrol Orientation (If Equipped )
N
ote:
If your luminaire is equipped with a photocontrol
receptacle, see IB525002EN Photocontrol
Receptacle Supplement to identify your photocontrol
and follow the instructions on the diagram and all
applicable notes.
Figure 4.
Bi-Level Switching (If Equipped)
For Bi-level switching, the input leads to the fixture will be
independently labeled to indicate dimming preferences as
appropriate (as defined by the order requirements). Two
separate supply lines of line voltage, neutral and ground
must be connected to the fixture leads to enable the bi-level
switching functionality of the fixture.
Maintenance
A regular maintenance schedule should be followed to
retain optimal light output and thermal performance. Optical
lens cleaning should be performed with a clean dry cloth to
remove any dust or other contaminants. Additional cleaning
can be performed with non-abrasive acrylic cleansing
solution.
Cooper Lighting Solutions
IB50078323
PCR
Installation instructions
3
Publicité
