Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – Galleon Wall Slim
Wall Mounting
Tools required:
•
#2 Phillips head screwdriver
•
Allen wrench
Wall Mount Adapter
(2) 1/4-20 Set Screws Tightening
Figure 1.
1.
Remove the wedge plate by loosening the (2) 1/4-20
set screws on the fixture with the Allen wrench.
2.
Attach the wedge plate to the wall or junction box.
Wedge plate must be mounted with hardware able to
support a fixture weight of up to 30 lb.
The fixture is fully sealed and does not require any
N
ote:
additional water proofing.
3.
Hang the fixture from the wedge plate using the hanger
located on the back of the fixture. Wire hanger can be
located by looking for the red flag label.
4.
Make wiring connections per wiring diagram. (Figure 1)
a.
Supply side ground wire to green fixture lead.
b.
Supply side neutral wire to white fixture lead.
c.
Supply sideline voltage wire to black fixture lead.
Dimming wires will not exit fixture when fixture
N
ote:
is ordered with motion control device. If external
dimming control is not used, then cap off gray and
purple wires where available.
5.
Lift the fixture off the wire hanger and onto wedge
plate. Ensure that the luminaire supply leads are not
pinched between the wedge plate and the housing.
6.
Retighten the two set screws on the fixture to
20 in-lbs.
2
Cooper Lighting Solutions
Wedge Plate
Wall
Torque 20 in-lbs
IB50078323
Installation instructions
Accessories Mounting
Wire Guard
Tools required:
•
Torx screwdriver T20
•
#2 Phillips screw driver
Tightening Torque
12-14 in-lbs
Figure 2.
1.
Loosen and remove the existing (4) 8-32 torx screws on
the face of the fixture (Figure 2).
2.
Align wire guard on top of lens clips matching the four
existing holes.
3.
Use (4) 8-32 Phillips screws provided to tighten the
wireguard in place onto each LED square.
4.
To remove wire guard, follow steps 1-3 in reverse order.
Publicité
