Daga Flexyheat Colors Mode D'emploi page 7

All manuals and user guides at all-guides.com
ENGLISH
breakdown and contact an authorised Technical support service.
In order to prevent any risk of danger, do not open the control or
connection. Only qualified technical personnel from the brand´s
Official Technical support service may carry out repairs or procedu-
res on the device.
Any incorrect use or improper handling of the product shall render
the warranty null and void. Only an authorised technical support
service centre may carry out repairs on this product.
B&B TRENDS, S.L. disclaims all liability for damages that may
occur to people, animals or objects, for the non-observance of
these warnings.
INSTRUCTIONS FOR USE
Prior to connecting the product to the mains, check your power
supply voltage to ensure it is the same as the one indicated on the
label included on the product. Connect the product to the appro-
priate mains.
In order to turn on the product, you must select the slider switch
on the control, setting it to position 1, 2 or 3 (Fig.1).
From this time on, the product is operational.
The maximum operation time is 90 minutes, after which the auto-
matic safety shut-down will immediately activate The product will
no longer heat up when in this state.
Select the " 0" position in order to turn off the product before you
disconnect the device from the mains.
TROUBLESHOOTING GUIDE:
Possible operational problems
PROBLEM
The regulator control does not
light up when the switch is
turned on.
After a certain operation time,
the product temperature seems
to reduce.
Manual Flexyheat Colors.indb 7
RECOMMENDATION
Ensure that the regulator is
properly connected to the pro-
duct and that there is voltage
in the socket of the mains used
and that the product is properly
plugged in.
The product has an auto-stop
system that activates after 90
minutes of continuous opera-
tion. After this time, the light
on the regulator starts to flash.
If you want to continue to use
it, change the temperature
level to level 0, wait a few
seconds, and then select the
desired temperature.
7
6/11/15 12:36