Allen + Roth LWSE36VBR Instructions De Montage page 2

ASSEMBLY INSTRUCTIONS
Step 1:
Attach center support rail (E) to metal legs (D) by inserting the
bolts (BB) through lock washers (DD) and flat washers (EE).
Tighten with hex wrench (FF).
Hardware Used
BB 1/4 x 1/2 in. Bolt
DD Lock Washer
EE
Flat Washer
FF
Hex Wrench
Step 2:
Attach center support rail (E) and metal legs (D) to the
vanity base (B) by inserting the bolts (CC) through lock
washers (DD) and flat washers (EE). Tighten with hex
wrench (FF).
Hardware Used
CC
1/4 x 1-3/4 in. Bolt
DD
Lock Washer
EE
Flat Washer
FF
Hex Wrench
Step 3:
Mark wall for vanity placement and note the location of the
water supply lines and drain on the back panel of vanity.
All manuals and user guides at all-guides.com
v
1
D
x 4
x 4
E
BB
x 4
DD
x 1
v
2
B
x 6
x 6
EE
DD
x 6
v
3
x 1
3
ASSEMBLY INSTRUCTIONS
Step 4:
Move vanity (B) into proper place against the wall.
EE
Step 5:
Install faucet, drain and supply lines (none included) to
vanity top (A) according to the instructions supplied with
those items.
D
E
CC
Step 6:
In case of uneven floors, floor levelers are provided at the
bottom of the vanity. If necessary, adjust floor levelers by
hand to correct tilting and/or level doors.
v
4
B
v
5
v
6
4
A