Kohler K-1110 Guide D'installation page 13

Flexjet Flow Mode
Activates Mode
Selected
Backjet Mode -
Adjust Pulse
Rotate outer
ring to access
desired mode.
Power On/Off
Chromatherapy -
Specific Color
Lighted User Keypad
14. Confirm Proper Operation
Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
Turn the jet trim rings fully counterclockwise. Position the jet nozzles so they face down toward the
basin.
Fill the whirlpool until the water level sensors (if equipped) are submerged. If your whirlpool does
not have sensors, fill the whirlpool to a level at least 2" (5.1 cm) above the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.
15. Operating Sequence
NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is
running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at
higher temperatures.
IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and
optional remote control.
NOTE: The keypad above shows features for all models. Your keypad may vary based on your whirlpool
model.
Press the Power On/Off button to turn on the whirlpool. The whirlpool will start at medium flow.
Increase or decrease the water flow by pressing either the up or down arrow buttons on the keypad.
An indicator bar in the center of the keypad shows the water flow volume.
Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air flow,
and counterclockwise to increase the air flow.
Rotate the outer ring until the heater button is flashing. Press "OK" to turn the heater off. Press
"OK" again to turn the heater back on. The heater will help to maintain the water temperature up to
104°F (40°C).
Press the Power On/Off button a second time to turn the whirlpool off.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
Kohler Co.
All manuals and user guides at all-guides.com
Neckjet Mode -
Adjust Pulse
Increases Flow or Pulse
Indicator Bar - Shows water
flow volume or pulse rate
Effervescence Mode
Decreases Flow or Pulse
Chromatherapy Cycle
Heater On/Off
13
Turn the jet trim
clockwise to
decrease the flow.
Turn the jet trim
counterclockwise to
increase the flow.
1022365-2-C