Alpina GLA-1006 Manuel D'utilisation page 9

Fat Collecting Tray
The fat collecting tray should always be inserted so that any dripping fat, crumbs
or other food residues can be collected on it. It slides into the bottom of the
cooking space.
Baking Racks
The baking racks are intended for drying. However, they can also be used for
crisping, warming up etc.
The baking racks are slid onto the rails in the cooking space. The heating
element is located at the top of the cooking space, i.e. the higher up a baking
rack is placed, the more intense the heat is from above.
In the top section, the food is cooked faster and crispier. The middle position
should be chosen to achieve even heating from all sides. The bottom rails are
suitable for gentle cooking.
Rotisserie Spit
The rotisserie spit consists of the shaft and two spit forks. The rotisserie spit is
suitable for grilling large pieces of meat, e.g. chicken, grilled or roast pork.
Assemble the rotisserie spit and insert it into the device:
PLEASE NOTE!
The shaft contains two small round notches marking the outermost
■
position of the locking screws. These must not be attached any further
than the outer ends of the shaft to ensure that smooth operation is
possible.
■ Do not place any pieces that are too large onto the rotisserie spit so
that it can rotate without any hindrance.
1. Slide one of the spit forks onto the shaft and lock it with the locking screws.
The shaft contains a small round notch for the tip of the locking screw. In the
case of smaller pieces of food, the spit forks can be secured more centrally on
the shaft.
2. Slide the items you want to grill onto the spit fork.
3. Slide the other spit fork onto the shaft and food and lock it with the locking
screw.
4. Plug one end of the shaft into the round holder on the left-hand side of the
cooking space. Then hang the other end of the shaft into the support on the
right-hand side of the cooking space.
5. Check that it fits securely. The rotisserie spit must not be able to rotate about
its own axis when the device is switched off. If this is not the case, plug the left-
hand end of the shaft deeper into the holder.
9