Klarstein 10033239 Mode D'emploi page 21

All manuals and user guides at all-guides.com
3 The area of the admission inlet and exhaust outlet should not be less than 250 m
degrees to ensure smooth flow of air admission and exhaust. Do not put the
refrigerator into a closed cabinet.
Note: The area of space around the ventilation grid should be at least 250 cm
Hints for optimal storage and low power consumption:
• Do not place the refrigerator near a heat source and avoid direct sunlight.
• Do not place equipment near the cooling system that obstructs the air flow.
• Never cover the ventilation grid by anything, such as decorations and clothes etc.
• Place the refrigerator on a steady and level surface.
OPERATION
Befor first use
• Before using the appliance for the first time, clean the interior and all internal
accessories (see section "Cleaning and Maintenance" in this manual).
• Wait about 5 to 6 hours after switching on the refrigerator before putting food
inside. The interior will then be sufficiently cooled.
Adjusting the shelves
• The height of the shelves can be freely adjusted conducive to store articles with
various sizes.
• Do not put heavy articles on the shelves so as to avoid overloading and damage to
the shelves.
Setting the thermostat
• The refrigerator mounted a microprocessor controlled thermostat.
• The knob of the thermostat is located at bottom of inside back
wall.
• If you want a lower inside temperature, please turn the knob
clockwise. If you want a higher temperature, please turn the knob
anti-clockwise.
Automatic defrosting
• The refrigerator has a function of automatic defrost: the refrigerator will start its first
defrost at 15 hours after switch on and the defrost will take 1 hour.
• Then the refrigerator will do defrost after every 23 hours of operation, the duration
of defrost will be 1 hour. The defrosted water will go to the water collection tank,
then flows into water storage tank, and then naturally evaporates.
2
2..
HI
LOW
EN
21