Assembly Of Drill Motor; Adjust The Column Tilt; Drilling In The Ceiling - Husqvarna DS150 Manuel D'utilisation

Fixing with threaded rod, washer and lock
nut
If the mounting surface is inadequate for drilling in roofs or
walls, the baseplate can be fixed using a threaded rod, which
is mounted on the back end with a washer and locking nut.

Assembly of drill motor

IMPORTANT! Always pull out the plug from
!
the outlet socket before cleaning,
maintenance or assembly.
• Always remove the drill bit before the motor is mounted or
dismounted.
• Lock the feed housing lock.
Collar assembly
DS150
• Fasten the drill spindle to the collar. Use the feed handle.
Quick mounting bracket assembly
DS250, DS250 Single speed
• Fit the quick mounting for the drill motor in the track on the
locking clamp. Make sure that the quick-mount is pushed
all the way to the bottom (1) of the rail on the locking clip.
• Secure with the locking handle (2).
3
1
2
Use top positioned locking screw (3) only together with DMS
240.
ASSEMBLY

Adjust the column tilt

Loosen the locking screws for column tilt and set the desired
drill angle. Tighten the locking screws. Use the feed handle.
The column can be tilted 0-60°.
The angle indicator can be used for approximate adjustment.
If higher precision is required, alternative measuring methods
should be used.

Drilling in the ceiling

!
WARNING! Use a water collector to avoid
water penetrating into the machine. The
machine must be covered with plastic or the
like in order to prevent water penetrating
into the machine, but do not cover the air
intakes and air outlets.
– 11
English