Assembly - Husqvarna BR600 Manuel D'utilisation

• Check the entire product before starting. Replace
damaged parts.
• Check that all guards and covers are complete and
attached correctly. Examine all nuts and screws.
• If you have a gasoline operated product, make sure
that there are no fuel leaks.
• Check that the brush drums are not damaged and
show no signs of cracking or other damage.
To assemble the attachment
1. Press one of the drum axles (A) onto one of the two
outgoing drive shafts from the gear housing (F).
Rotate the drum axle if necessary so that the pin
hole comes over the corresponding hole in the drive
shaft.
2. Fasten the roller shaft with locking pin (B).
3. Put one of the brush rollers (C) onto the assembled
shaft. Press in the roller until it stops.
4. Fasten the roller on the shaft with a cotter pin (D).
Press in the end slightly when assembling.
6

Assembly

E
F
B
D
A
C
E
5. Repeat these steps to assemble the axle and roller
on the opposite side.
6. Mount the splash guard with the snap-on fasteners
(E).
Note: For assembling accessories on basic product,
refer to manual for basic product.
738 - 003 - 13.12.2019