Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
Pay
attention
to
properly position the
magnetic
chevron
clamp: the sides of
the chevron must be
parallel
to
back
fences 1 and 2.
Now
with
quick-
change
magnetic
clamps, it is easy to
change from chevron
to a round clamp.
Simply pull down the
Z24703 to change of
clamp support.
3.C
SPECIFIC USE OF THE SPACER BARS
When joining small
mouldings
(lower
than the height of
the back fences), it is
necessary to use the
set of spacer bars
supplied with the
SPACERS
machine.
The spacer bars are
made of two steel
bars linked with a
screw locked by a
nut. The nut side is
the bottom side of
the spacer bars
All manuals and user guides at all-guides.com
Example
setting
chevron.
Figure 3-7
Figure 3-9
This is an example of
a bad setting, the
spacer bar not being
used will cause the
top clamp not to hold
the
correctly.
moulding will jump
up during stapling.
Figure 3-10
Here the spacer bars
are upside down.
The nut is visible on
the top, which is not
correct.
Figure 3-12
of
bad
of
the
moulding
The
CS200 CART
Figure 3-8
Figure 3-11
Figure 3-13
14
Publicité
