Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
2.B
AIR LINE FITTINGS
Quick
release(Q/R)
Female
Air Connector
- Z749
Quick
release(Q/R)
Female
2.C
CONNECTING TO THE AIR SOURCE
Air Connector
- Z749
The machine should be connected to a pneumatic circuit providing 6 to 8 bars pressure.
Connect the machine
using
the
quick
connectors
as
mentioned in chapter
0
The red knob in Figure 2-5 must be used to secure the machine during maintenance or to prevent non desired
use. A lock can be applied to it in stop position so nobody can turn it back to ON. This will exhaust air from the
machine circuit and disconnect it from air supply. Refer to chapter I.5.A
further instructions.
If the indicated pressure is not 6 bars (85 p.s.i.), check the pressure at the air source (compressor). Then, if pressure is correct at
the air source, it means the regulator of the machine needs fine tuning. Perform the following procedure to adjust it (Figure 2-6
and Figure 2-7)
All manuals and user guides at all-guides.com
Included in the machine
Standard hose connector - Z556
Q/R US male connector - Z701
Figure 2-4
Customer's air connection
The CS200 CART must
be connected to the
air source located on
the front panel of the
drawer.
Turn
the
compressed air valve
to ON by rotating its
red knob .
The
air
pressure
gauge should show 6
bars
(85
p.s.i.)
minimum.
SAFETY INSTRUCTIONS
CS200 CART
Figure 2-5
(page 20) for
11
Publicité
