Publicité
Les langues disponibles
Les langues disponibles
General information
During average length vacations, you will probably find it best to leave the refrigerator
Vacation time
in operation. Place freezable items in freezer for longer life.
When you plan not to operate, remove all food, disconnect the power cord, clean the
interior thoroughly, and leave each door OPEN to prevent odor formation.
Power failure
Most power failures that are corrected in an hour or two will not affect your
refrigerator temperatures.
However, you should minimize the number of door openings while the power is off.
Remove or securely fasten down all loose items inside the refrigerator.
If you move
To avoid damaging the height adjusting screws, turn them all the way into the base.
The outside wall of the refrigerator cabinet may sometimes get warm, especially just
Anti
after installation.
condensation
pipe
Don't be alarmed. This is due to the anti-condensation pipe, which pumps hot
refrigerator to prevent "sweating" on the outer cabinet wall.
Caution
•
•
Cleaning
It is important that your refrigerator be kept clean to prevent undesirable odors. Spilled
food should be wiped up immediately, since it may acidify and stain plastic surfaces if
allowed to settle.
Exterior
Use a lukewarm solution of mild soap or detergent to clean the durable finish of your
refrigerator.
Wipe with a clean damp cloth and then dry.
Interior
Regular cleaning is recommended. Wash all compartments a baking soda solution or a
mild detergent and warm water. Rinse and dry.
After cleaning
Please verify that the power cord is not damaged, power plug is not overheated, or
power plug is well inserted into the power consent.
Warning
Always remove power cord from the wall outlet prior to cleaning in the vicinity of
electrical parts (lamps, switches, controls, etc.).
Wipe up excess moisture with a sponge or cloth to prevent water or liquid from
getting into any electrical part and causing an electric shock.
Never use metallic scouring pads, brushes, coarse abrasive cleaners, strong alkaline
solutions, flammable or toxic cleaning liquids on any surface.
Do not touch frozen surfaces with wet or damp hands, because damp object will stick
or adhere to extremely cold surfaces.
42
You must check the O-RING, which is made by rubber and prevent electric
spark.
Don't touch the lamp, in case of light on the long time. Because it can be very
hot.
Care and maintenance
Publicité
