Cooper Lighting Solutions Portfolio LDS6C Instructions D'installation page 2

Installation Instructions – Plug-in driver replacement-installation
Plug-In Driver Replacement/Installation
CAUTION
To avoid possible electric shock, be sure that the power is
turned off before installing or servicing the fixture.
• The driver should be replaced by a qualified electrician.
• The driver maybe replaced either from below or above
the ceiling (if ceiling access is present).
1. Remove trim and LED module assembly from the
housing. Refer to the housing installation instructions
2. Hold and pull the plug-in driver box assembly until it
disconnects (Figure. 1).
3. If replacing from below the ceiling align the plug-in
driver box assembly with the housing opening and take
it out through the hole in the ceiling.
4. Bring in the new plug-in driver box assembly while
ensuring the INSTALL THIS END UP arrow points
upwards (Figure. 2) and rest it on the housing.
5. Align the plug-in driver box assembly with alignment
flanges & the connector on the junction box and gently
push it to the end till the connector engages
(Figure. 1).
6. The trim and LED module assembly can now be
reinstalled into the fixture. Refer to the housing
installation instructions
Alignment
Flanges
Plug-in
Driver Box
Assembly
Figure 1
2
Installation Instructions – Plug-in driver replacement-installation www.cooperlighting.com
Figure 2
Connector
Junction
Box