Amprobe TMD-50 Mode D'emploi page 11

All manuals and user guides at all-guides.com
key once more to cancel the Back-Light function.
Back-Light on lighter Back-Light off
1. Insert the bead wire into a known temperature (T)
until the display equal to known temperature (T).
exp: ice point at 0°C boiling water at 100°C (Press
" " key).
2. Press " " or " " to add or subtract the value.
3. It can be adjusted ±6°C (±10.8°F) of default. If you
the meter to be calibrated.
4. Press " " key to confirm.
Press " " key to enter Relative mode, zero the display,
and store the displayed reading as a reference value and
annunciator REL is displayed. Pressing "
seconds to exit the relative mode.
Press the " " key to enter the Data Hold mode,
the " " annunciator is displayed at the higher
center of display. When HOLD mode is selected, the
thermometer held the present readings and stops all
further Measurements. Press the "
cancels HOLD mode, causing thermometer to resume
taking measurements.
Press " ", " ", " " key to select input mode T1,
T2 or T1-T2.
The input selection indicates which input is selected
for display. T1 thermocouple, T2 thermocouple or the
differential between the two thermocouples(T1-T2),
when the thermocouple is turned on, it is set to T1.
4
" key over 2
" key again