Publicité
Les langues disponibles
Les langues disponibles
Turn off your appliance
▪
If the unit is not likely to operate for a long period of time:
▪
Remove all food from your appliance from the refrigerator.
▪
Switch off the appliance by setting the thermostat to position OFF.
▪
Unplug the appliance.
▪
Clean it thoroughly.
▪
Keep the door open to prevent odors from rising.
Energy saving tips
▪
The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
▪
Let hot foods cool to room temperature before placing in the refrigerator. Overloading the
refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose
quality, or spoil.
▪
Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.
▪
Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the refrigerator less efficient.
▪
Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
Replacing light
This appliance consists of light-emitting diodes (LEDs). This
type of diode cannot be changed by the consumer. The lifetime
of these LEDs is normally sufficient for no change to be made.
If however, and despite all the care taken during the
manufacture of your appliance, the LEDs were defective, please
contact your after-sales service for any intervention.
Door reversal instructions
CAUTION! Unplug the appliance before you change the hinge position. Empty the appliance.
Carry out the change with at least 2 persons.
4. Dismantle the upper cover fitting screws of upper hinge, and remove the upper hinge, please
keep the door vertical in whole process for avoiding falling down.
35
Publicité
