Publicité
Les langues disponibles
Les langues disponibles
WATERDROPS & CONDENSATION
All manuals and user guides at all-guides.com
Regulary check the lens to see if waterdrops or condensation/fog have appeared as these
may be shown on your footage.
To remove/avoid waterdrops and condensation/fog, these tips might help :
•
Spit or lick the port or housing lens. The water will sheet off instead of beading up!
•
Apply a water repellent and anti-beading/ anti-fog coating or wax (such as 'RAIN-X)
•
Make sure the inside of the housing and camera is as dry as possible (e.g. dry hands,
no sweat) to prevent fog/condensation
•
Don't leave the camera in the direct sun or near heat and don't leave it ON
(generating heat) when not necessary
•
Open the fogged camera housing and carefully wipe off the fog inside, then close it again
•
Try to avoid too large temperature differences as these may cause condensation/fog
Anti Fog inserts are optionally available on www.guardo.be
Note: 'Muffled' sound is inevitable when using the camera with the waterproof housing.
MOUNTING THE CAMERA USING THE
Attaching the camera to any mount, is always done in the same way:
1. Place the camera on the mount's screw 2. Rotate/point the camera as desired
DELIVERED MOUNTS
and fasten with the tightening screw
3. Tilt the camera into the desired
shooting angle and fasten with the
tightening screw
11
Publicité
