Publicité
Trouble
• Remote (if
☛ Battery low.
applicable)
☛ Distance too far.
Does not
work.
☛ Control Panel Display dirty.
• Heater is
☛ When the heater is in Thermostat
Blowing
Mode and reaches the set
Cold Air.
temperature it will automatically
perform a 15 second cool down
(blowing cold air) to ensure
thermostat accuracy.
☛ Unit is in the Fan Only setting.
☛ Power Button may have been pressed
to turn off the heater.
• Fan Speed
☛ Max and Low/Heat & $ave
Doesn't
control the heat output of the heater
Change.
and not the fan speed. Fan runs at
the same speed on all settings.
• Unexpected
☛ You may hear a popping or crackling
Noise.
sound as the heater heats up. This is
normal and safe operation. Once the
heater heats up, the crackling sound
will go away.
☛ There may be an odor or vapor
• Unexpected
Smell.
coming from the heater the first time
you use it or after prolonged or
seasonal storage.
© 2014 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and
distributed by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, 20 B Hereford
Street, Brampton, Ontario L6Y 0M1.
All manuals and user guides at all-guides.com
T R O U B L E S H O O T I N G
Troubleshooting for your Heater
Probable Cause
settings
TM
Solution
✔ Change battery (Disc type, 3 volt, CR2025).
✔ Remote works up to 20 feet (6m).
✔ Be sure to point remote at control panel on heater
and there are no obstructions.
✔ Make sure display panel is clean.
✔ Raise the temperature higher or change setting to
Low/Heat & $ave
or Max.
TM
✔ Press the Max or Low/Heat & $ave
✔ Press the Power Button to turn on the heater.
✔ Run heater in Max for maximum heat output.
✔ If the noise persists call Bionaire at
1-800-253-2764.
✔ This is normal and is the result of dust or other debris
accumulating on the heating element. Make sure the
heater is in a well ventilated area and continue
running until the odor or vapor goes away.
Buttons.
TM
Printed In China
Publicité
