Publicité
F E AT U R E S - O P E R AT I O N S
(either one or two-piece base) first make sure
the side marked "Rear" is facing the back of the
heater. Line up holes of the base with holes on
bottom of pedestal (or heater housing if no
pedestal is included), and secure with 4 provided
screws. Refer to Figure 4.
Step 3:
Lace the power cord through the cord minders on
the underside of the base. Refer to Figure 5.
Step 4:
Turn the heater right side up on a flat level
surface prior to beginning operation.
Remote Control (if applicable)
If your heater comes with a remote control, unpack the
remote control from box. This includes one lithium battery,
CR2025/3V. Please note this remote control will not work
through walls. Remove battery before discarding the remote.
NOTE: REMOVE THE PROTECTIVE COVER FROM THE BATTERY
PRIOR TO BEGINNING OPERATION.
Battery Replacement
1. Locate the battery compartment on the back of the
remote control handset. Insert a small object (such as a
pin or paper clip) into the hole of the battery cover lock
(see Figure 6) and slide out the battery cover.
2. Remove old battery.
3. Place new battery into battery compartment.
4. Slide battery compartment into the remote control
Figure 6
B
A. Battery Cover Lock
B. Battery cover
All manuals and user guides at all-guides.com
A
Insert pin here
handset until the Battery Cover Lock is securely latched.
5. For your convenience, a remote control holder is
integrated into the back of the heater housing.
NOTES:
• Remove the battery from the equipment when it is not
being used for an extended period of time.
• Remove the used battery promptly.
• Do not discard used batteries into household trash
containers. Contact your local government for disposal or
recycling practices in your area.
This Class B digital apparatus complies with Canadian
ICES-003.
OPERATING INSTRUCTIONS
1. Place heater on a firm, level surface.
2. Plug heater into a standard outlet. Once plugged in, the
Power Light will illuminate.
NOTE: Avoid overloading your circuit by not using other
high wattage appliances in the same outlet. At 1500
watts, this unit draws 12.5 Amps.
3. Operate heater by pressing the Power Button ( ) and
selecting modes and settings according to preference.
NOTE: Remove the plastic film from the control panel
before using (if included).
Power On/Off
Press the Power On/Off Button to turn the heater on. Once
on, the heater will run in the Max Heat mode and the Stay
On icon will appear on the LCD Display. Press the Power On/
Off button to manually turn off the heater at any setting.
NOTE: The Power Light will remain illuminated while unit is
plugged in.
Mode Selection
Select your desired heat settings by pressing the
corresponding buttons as located on your heater or press the
Mode button on remote control (if applicable) to cycle
through the heat settings. An indicator light will illuminate
next to each button to indicate that the selected setting/mode
is activated.
NOTE: Settings and control buttons may vary slightly
between models.
Publicité
