Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
4
NOTE: This tool is equipped with 1/4 in. collet
from factory. When mounting an 1/8 in. shank
grinding accessory onto tool, you need to first
replace the collet (D2) with the 1/8 in. collet (K)
using the large wrench (E) and small wrench (F).
Release the collet jacket (B2) with the large
wrench (E) by turning counterclockwise while
holding the small wrench (F) on the flats of the
collet holder (C2). Insert the 1/8 in. collet (K) into
the collet holder (C2). Mount the collet jacket (B2)
onto tool and tighten it with the large wrench (E)
and the small wrench (F).
CARE AND MAINTENANCE
An in-line oiler is recommended to be installed on air supply line as it increases tool
life and keeps the tool in sustained operation. The in-line oiler should be regularly
checked and filled with air-tool oil. Proper adjustment of the in-line oiler is performed
by placing a sheet of paper next to the tool's exhaust ports and holding the throttle
open approximately 30 seconds. The in-line oiler is properly set when a light stain of
oil collects on the paper. Excessive amounts of oil should be avoided.
In the event that it becomes necessary to store the tool for an extended period of
time, it should receive a generous amount of lubrication at that time. The tool should
be operated for approximately 30 seconds to ensure oil has been evenly distributed
throughout the tool. The tool should be stored in a clean and dry environment.
Recommended lubricants: use air-tool oil or any other high-grade turbine oil
containing moisture absorbent, rust inhibitors, metal wetting agents and an EP
(extreme pressure) additive.
Clean the tool with a cotton rag after each use. Keep the tool in a dry and safe place
out of reach of children.
17
Publicité
