Kobalt SGY-AIR166 Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
3. Place 2 to 3 drops of air tool oil (not included)
into the male plug (L) before each use.
4. Release the bolt (E1) and washer (F1) with the
hex key (J) by turning counterclockwise
while holding the wrench (G) on the flats of
the collet holder (G1).
5. Mount a cutting wheel (B1) onto the 3 in. air
cut off tool (A1). Re-attach
and bolt (E1) with the hex key (J) by turning
clockwise while holding the wrench (G) on the
flats of the collet holder (G1). Make sure the
cutting wheel (B1) is installed securely and
tightly.
Only use cutting wheels that have an RPM
rating equal to or greater than the tool itself.
All manuals and user guides at all-guides.com
the washer (F1)
WA R N I N G
3
4
5
11