Publicité
EDGE CLEANING BRISTLES: REMOVAL & REPLACEMENT
TOOL REQUIRED: Phillips screwdriver
WARNING: To reduce the risk of injury from moving parts, unplug before servicing.
TO REPLACE EDGE CLEANING BRISTLES
1
Remove two (2) screws from
each edge cleaning bristle.
WARNING: To reduce the risk of injury from moving parts, unplug before servicing.
PROBLEM
Cleaner won't run
Cleaner won't pick-up
or low suction
Dust escaping
from cleaner
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
AERUS CUSTOMER SERVICE: U.S.: 800.243.9078 AND CANADA: 800.668.0763
In the event that further assistance is required, visit your nearest authorized Aerus location or call Aerus Customer
Service at 800.243.9078 (U.S) and 800.668.0763 (Canada). The service parts used in this unit are easily replaced and
readily available from an Authorized Aerus Franchisee. Always identify your cleaner by the model number and serial
number when requesting information or ordering replacement parts. (The model and serial number appear on the rear
of the cleaner.)
14
All manuals and user guides at all-guides.com
2
Remove and dispose of old
bristles and replace with
new bristles on each side.
TROUBLESHOOTING GUIDE
POSSIBLE REASON
Power cord not firmly plugged into outlet.
Blown fuse or tripped breaker.
Service required.
Filter bag not installed correctly.
Filter bag is full.
Brushroll worn.
Broken or worn belt.
Filter bag is full.
Filter bag not installed correctly
3
Replace all four (4) screws
to secure.
POSSIBLE SOLUTION
Plug unit in firmly.
Check fuse or breaker in home. Replace
fuse/reset breaker.
Contact nearest Aerus location
for service.
Review filter bag removal & replacement,
p. 10.
Remove/replace filter bag, p. 10.
Replace brushroll, p. 12.
Replace belt, p. 12.
Replace filter bag, p. 10.
Review filter bag removal & replacement,
p. 10.
Publicité
