Publicité
BELT OR BRUSH ROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: Phillips screwdriver
WARNING: To reduce the risk of injury from moving parts, unplug before servicing.
TO REMOVE OLD BELT
1
Tab
Turn cleaner over. Base should lay flat and face up. To remove nozzle
guard, remove the two (2) screws near brushroll (Diagram 1). Release the
nozzle guard by pulling tab toward the front of the cleaner and rotate/pivot
the nozzle guard up to lift off (Diagram 1a).
TO REPLACE A NEW BELT
3
Slip brushroll through belt.
Place belt in area of brushroll
without bristles.
6
Tab
Three Insert Guides
12
All manuals and user guides at all-guides.com
1a
4
Motor
Shaft
Loop belt around motor shaft.
To reassemble the nozzle
guard, align the three (3)
insert guides on the front of
the nozzle guard with the
slots in the base. Rotate/pivot
the nozzle guard back into
position making sure that the
tab is fully engaged back by
the rear wheel.
2
Be sure belt is off motor
shaft. Lift and remove
brushroll. Dispose of old belt.
5
With new belt in place, pull and
slide brushroll onto nozzle making
sure that the brushroll end caps
are in the correct orientation (see
inset). Rotate brushroll manually to
make sure belt is properly aligned.
7
Replace the two
(2) screws to
secure nozzle
guard.
Publicité
