Motion CMD-02 Mode D'emploi page 13

All manuals and user guides at all-guides.com
18 Recharge the battery
Use a micro USB cable to charge the motor.
LED light flashes
red during operation;
Charge the battery
Frequently Asked Questions
Problem
Blind does not work.
Motor LED flashes red.
Blind is not charging.
Blind moves in small steps.
Favourite position can not
be programmed.
Blind lowers too far.
Blind moves in the opposite
direction
The blind keeps moving up and
down.
M O T I O N C M D - 0 2 T U B U L A R M O T O R
LED light flashes
green;
battery is charging
Cause
Motor is not activated
Motor battery is empty.
Remote battery is empty. (LEDS of remote
are flashing rapidly.)
Remote battery is inserted incorrectly.
Radio-frequency interference
The distance from the remote to
the motor is too far.
The remote is not connected to
the blind.
The battery of the motor is empty.
Charger is not plugged in or does not work.
No end limits are programmed.
No end limits are programmed.
End limits are programmed incorrectly.
The rotational direction has been
set incorrectly.
The blind is in program mode.
LED light constantly
green;
battery is fully charged
Solution
Activate the motor. See step 1.
Charge the motor. See step 18.
Replace the battery in the remote.
See the manual of the remote.
Replace the battery in the remote.
See the manual of the remote.
Make sure that the antenna of the motor is
out of the way of metal objects.
Move closer to the motor.
Pair the remote with the motor.
See step 6.
Charge the motor. See step 19.
Try a different charger or make sure the
charger is plugged in the outlet.
Program end limits. See step 8 - 11.
Program end limits . See step 8 - 11.
Reprogram end limits. See step 8 - 11.
Change the rotational direction.
See step 7
Press the program button on the motor
to exit program mode.