Motion CMD-02 Mode D'emploi page 12

All manuals and user guides at all-guides.com
16
Reset favourite position
Centre
17
Reset the blind
It is possible to only delete end limits or to do a factory reset.
Factory reset will delete the end limits and remove the connection to any paired remote.
Shortly press the program button on the motor to activate program mode.
17.1
Delete end limits: to delete the end limits of the blind, hold the program button
until the blind stops stepping for the first time, and keep holding the button until
the blind stops stepping for the second time. (approximately 10 seconds)
Factory reset: to reset the blind to factory defaults, hold the button for at least 20 seconds. The blind will
stop stepping twice. After the second stop, the blind will give one extra step to confirm factory reset.
M O T I O N C M D - 0 2 T U B U L A R M O T O R
Move the blind to a desired favourite position.
16.1
Press the program button on the motor to activate
16.2
program mode. The blind starts stepping.
Hold the centre button to save this favourite position. The blind
16.3
shortly stops stepping, indicating the favourite position has
been saved succesfully.
Press the program button on the motor to deactivate
16.4
program mode. The blind stops stepping.