Zycoo SC15 Guide D'installation Rapide page 4

Installation Method 2
1
To install the ceiling speaker with mounting brackets, please first fix the two plates to the
plastic ring.
2
Cut a hole in the ceiling with 206±1 mm diameter.
3
Connect network cable and power supply (if PoE is not enabled on the network cable),
and other cabling if required.
4
Detach the metal mesh (adsorbed by magnets).
5
Place the mounting bracket on top of ceiling, push the speaker back end into the ceiling
through the mounting bracket ring and ensure the mounting bracket is tightly attached
to the ceiling.
6
Adjust the clips for being able to clamp with the mounting bracket.
7
Tighten the screws of the 4 clips in order to tighten the clamping of the clips with the
mounting bracket and the ceiling, and then cover the metal mesh.
φ206mm
2
Bracket
Metal Mesh