Publicité
Les langues disponibles
Les langues disponibles
installing your washer
2. Insert new rubber washer (supplied) into each end of the
inlet hoses. Firmly seat the washers in the couplings.
3. Check the inlet hose to ensure a washer is inside each fill
hose.
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber washer
per hose and install each fill hose to the water valve. Make
sure the hose with the Hot printed line is attached to the
HOT faucet. Tighten by hand until snug, then two-thirds of a
turn with pliers.
For correct water use, connect both HOT and COLD water
valves. If one is not connected, an "nF" (no fill) error can occur.
4. Turn on the "HOT" and "COLD" water supply and check all
connections at the water valve and the faucet for leaks.
5. Plug the power cord into a 3-Prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp fuse or
comparable circuit breaker.
Your Washer is grounded through the third prong of the power
cord when plugged into a three-prong grounded receptacle.
6. Slide your Washer into position.
7. Level your Washer by turning the leveling legs in or out as necessary
by hand or wrench included with your Washer. When your Washer is
level, tighten the nuts using the wrench or (-) driver.
Your Washer must be leveled on all four sides.
A carpenter's level should be used on all four corners of your
Washer. It's a good idea after the first dozen washes to recheck
your Washer's levelness.
8. Before installing the rubber-cup, attach the tape provided to the base of the rubber-cup.
10_ Installing your washer
WF203ANW-02463A-02_EN.indd 10
2007-07-02 ¿ÀÈÄ 8:14:55
Publicité
