Sony CUH-ZVR1 Mode D'emploi page 7

Unusual or unresponsive behavior
Press the (power) button (
inline remote for at least 7 seconds to force a shutdown, and
then turn on the headset again. If the problem persists, restart
the PS4™ system.
High temperature message
If the processor unit's internal temperature becomes
elevated, a message will be displayed. In this case, turn off
the PS4™ system and leave it unused for a while. After the
processor unit cools down, move it to a location with good
ventilation, and then resume use.
AC adaptor and AC power cord use
• Use an electrical outlet that is easily accessible, so the AC
power cord can be unplugged quickly if the need arises.
Stop use, unplug the AC power cord from the electrical
outlet and disconnect any other cables immediately if the
product functions in an abnormal manner, produces
unusual sounds or smells or becomes too hot to touch.
• Unplug the AC power cord from the electrical outlet when
the status indicator on the processor unit is red. Unplugging
the cord while the indicator is white or flashing red may
cause a malfunction.
• Do not use an AC adaptor or AC power cord other than
those supplied with the product. The supplied AC adaptor
and AC power cord are designed exclusively for use with
this product. They cannot be used with other products. In
addition, other AC adaptors or AC power cords cannot be
used with this product. Failure to follow these precautions
page 11) on the VR headset's
may cause the product to overheat and may lead to fire or
electric shock.
– Do not plug the AC power cord for the product into an
electrical outlet until you have connected the HDMI ®
cables.
– Do not damage the AC power cord.
– Do not touch the plug of the AC power cord with wet
hands.
– Do not use the AC adaptor when it is covered by a cloth.
Heat could be trapped causing fire or malfunction.
– Unplug the AC power cord from the electrical outlet
before cleaning or when you do not intend to use the
product for an extended period of time.
– Do not connect the AC power cord to a voltage
transformer or inverter.
EN
7