ASSEMBLY
TO INSTALL THE HANDLE ASSEMBLY
See Figure 8.
Lift the end cap off the handle assembly using a flat blade
screwdriver.
Hold the lock nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle or the
washer from the end of the screw.
Place the lock nut into the recessed hole on the back of
the height/bevel adjusting handwheel and hold in place.
Slide the handle, screw, and washer into the hole on the
height/bevel adjusting handwheel.
Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
Push the end cap back in place on the end of the handle.
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 9.
WARNING:
The throat plate must be level with the saw
table. If the throat plate is too high or too low,
the workpiece can catch on the uneven edges
resulting in binding or kickback which could
result in serious personal injury. Verify the throat
plate is correctly seated. If the throat plate is still
not level, do not attempt to use the saw. Contact
customer service for assistance.
Lower the blade by turning the height/bevel adjusting
handwheel clockwise.
To remove the throat plate, place your index finger in
the hole and lift the front end, pulling the throat plate out
toward the front of the saw.
To reinstall the throat plate, first slip the tab into the slot
at the back of the saw and then push down to secure in
place.
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
16 − English
NUT
HANDLE
END
ASSEMBLY
CAP
THROAT
PLATE
RIVING
KNIFE
Fig. 8
Fig. 9