AENO SM2 Mode D'emploi page 12

4. When the appliance has finished operating, press the steam button (7)
again for 2 seconds. Unplug the appliance from the mains.
5. Wait until it has cooled completely and then wipe the mop with a clean, soft
cloth.
Note: you can adjust the steam mode with the steam button (7). The number
of lights (8) illuminated will change accordingly (from 1 for minimum mode to
3 for maximum mode).
WARNING! Keep an eye on the water level in the tank during use. Do not use
the steam mop with an empty tank; do not empty the tank during operation
as this could damage the appliance.
Troubleshooting
1. The steam mop does not heat up. Possible reason: the appliance is not
switched on or is not connected to the power supply. Solution: Ensure that
the appliance is switched on, the power plug is connected to the power
socket and that the power socket is in proper condition.
2. The steam mop does not generate steam. Possible causes: low water level
in the water tank; the appliance is not switched on or not plugged in.
Solution: Unplug the appliance and fill the tank with water; check that the
mop is switched on, the plug is connected to the socket and the socket is in
order.
3. The steam mop leaves water on the floor. Possible causes: the floor cloth is
too wet; wrong steam release mode. Solution: switch off the appliance,
detach and wring out the mop pad; select a different steam mode.
aeno.com/documents 12