AENO SM2 Mode D'emploi page 11

Jet nozzle Cleaning corners,
(14) skirting boards, gaps
between tiles and
other hard-to-reach
areas
Nylon brush
Removing
(12)
using a minor
mechanical action
Brass brush Removing stubborn
(13) soiling using a
mechanical action
Squeegee Cleaning glass and
mirror surfaces
(15)
Crevice Cleaning tile joints
brush (17)
Operation
1. Install the required accessories according to the table 1.
2. Plug the power cord plug into a power socket.
3. Press the steam button (7) for 2 seconds to start heating. Wait approx.
15 seconds until two LEDs (8) flash. Press the steam button (7) again to start
operation. Two LEDs (8) light up steadily and steam starts.
11
pad (11) to the Velcro of the steam mop
head (10) as shown in fig. J
Assemble the mop (see instructions
above). Attach the jet nozzle (14) to the
body of the steam mop (4) according to
figure G
soiling Attach the jet nozzle (14) to the body of the
appliance (see instructions above). Attach
the nylon brush (12) to the jet nozzle (14) as
shown in fig. H
Attach the jet nozzle (14) to the steam mop
body (4) (see instructions above). Attach
the brass brush (13) to the jet nozzle (14) as
shown in fig. H
Attach the jet nozzle (14) to the steam mop
body (4) (see above). Attach the squeegee
(15) to the jet nozzle (14) as shown in fig. I
Install the jet nozzle (14) on the device body
(4) (see above). Install the crevice brush (17)
on the jet nozzle (14) according to figure J
aeno.com/documents