AENO SM2 Mode D'emploi page 10

intended for use by children or persons with lack of experience and knowledge
without the supervision. Do not use the steam mop if the power cord is
damaged, contact an Authorized Service Centre for replacement. If the
appliance is damaged, do not disassemble or attempt to repair the appliance.
Do not use the steam mop for cleaning surfaces with a temperature resistance
of less than +100 °C. Use only purified water with no chemicals or detergents
added. Allow the steam mop to cool down completely before disassembling
and cleaning (at least 15 minutes). Do not use the brass brush on sensitive
surfaces, e.g. enamel, acrylics.
Before you begin
1. Unpack the mop and accessories.
2. Open the cover of the water tank (6) on the body of the appliance (4). Fill the
water tank (5) with water using a measuring cup (16). Put the cover (6) back.
Table 1. Function and installation of accessories
Nozzle
Steam mop Floor cleaning
head (10) together with
cleaning cloth (11)
Extension Extension of the
tube (2) appliance for effective
cleaning of floors and
hard-to-reach areas
Microfiber Gentle cleaning of
pad (11) hard floor coverings
aeno.com/documents
Destination
Connect the handle (1) to the extension
tube (2) and attach it to the steam mop
body (4). Slide the body (4) into the mop
head opening (10) as shown in fig. F
Insert the tube (2) with the handle (1) into
the steam mop body (4). Slide the steam
mop body (4) into the steam mop head (10)
as shown in fig. F
Assemble the mop (see instructions
above). Attach the underside of the mop
Build
10