Makita DA3000R Manuel D'instructions page 4

This machine has a reversing switch to change the
direction of rotation. Turn the reversing switch knob so
that its protrusion will point to
clockwise rotation or
wise rotation.
Drilling operation
• Drilling in wood
When drilling in wood, the best results are obtained
with wood drills equipped with a guide screw. The
guide screw makes drilling easier by pulling the bit
into the workpiece.
• Drilling in metal
To prevent the bit from slipping when starting a hole,
make an indentation with a center-punch and ham-
mer at the point to be drilled. Place the point of the
bit in the indentation and start drilling. Use a cutting
lubricant when drilling metals. The exceptions are
iron and brass which should be drilled dry.
CAUTION:
• Pressing excessively on the machine will not speed
up the drilling. In fact, this excessive pressure will
only serve to damage the tip of your bit, decrease
the machine performance and shorten the service
life of the machine.
• There is a tremendous force exerted on the
machine/bit at the time of hole breakthrough. Hold
the machine firmly and exert care when the bit
begins to break through the workpiece.
• A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back
out. However, the machine may back out abruptly if
you do not hold it firmly.
• Always secure small workpieces in a vise or similar
hold-down device.
4
All manuals and user guides at all-guides.com
marking for
marking for counterclock-
MAINTENANCE
CAUTION:
Always be sure that the machine is switched off and
unplugged before carrying out any work on the
machine.
Replacement of carbon brushes (Fig. 5 & 6)
Replace carbon brushes when they are worn down to
the limit mark. Both identical carbon brushes should
be replaced at the same time.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
Makita Authorized Service Center.