Heitronic 38277 Instructions D'installation Et D'utilisation page 6

GB Installation and Operating Instructions
LED Strip
Art. No. 38277, 38278
These operating instructions refer exclusively to the above products.
They contain important information for the start-up and handling of the product.
Therefore pay attention to these operating instructions, even if you pass this product on to
third parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of
technology.
The LED strip fulfils the requirements of effective European and national guidelines. To maintain the
condition of the product and to ensure safe operation, you - as the user - must observe the instructions of
this operation manual!
2. Safety Instructions / Warnings

The guarantee becomes invalid if damage occurs due to the failure of following these operating
instructions!

We do not accept liability for any consequential damage!

Do not switch the LED strip when rolled up.

Avoid staring directly into the LED when switched on!

We do not accept liability for any personal injury or damages to property caused by incorrect handling
or failure to observe the safety advice. In such cases, all warranty claims are rendered void.

The type plate must not be removed.
3. Proper Use
The LED strip is designed for use in outdoor/indoor areas.
This product is only intended for lighting purposes and may:

only be operated with a voltage of 24 V

only be connected according to protection class III (three)

only be operated when mounted to a sturdy, level and non-tilting surface.

only be operated on normal or non-flammable surfaces

not be subjected to strong mechanical loads or heavy soiling.
4. Before Installation/Commissioning

Take the LED strip carefully out of the packaging.

Make sure that the LED strip has not been damaged during transport before putting the light into
operation. The light may not be operated if there are any damages to electrical parts. Repairs may
only be carried out by a qualified electrician.

The light may only be operated once removed from the packaging.

Keep packaging materials away from children and pets. Asphyxiation hazard!
All manuals and user guides at all-guides.com
1 of 5 | Dated 18.05.2016