Publicité
Les langues disponibles
Les langues disponibles
2.2
Notes on special dangers
2.2.1 Electrical equipment /
installations
There must not be any electrical
cables and devices underneath or
in the immediate vicinity of the
phosphate dosing unit!
Electrical devices / equipment that are not
splash-water proof and are situated in the
direct vicinity of the phosphate dosing unit
may be damaged by water leaking from the
phosphate dosing unit caused as a result of
the device not being operated in accordance
with the manufacturer's specifications. In
addition this may also result in short circuits
where these electrical devices / equipment
being connected to the electrical power
supply. In the event of such cases persons
are at risk and may sustain electrical
shocks. Therefore any electrical devices /
equipment situated in the direct vicinity
should be splash water proof, respectively
comply with the statutory requirements for
wet areas (IP44).
6
Product Information
All manuals and user guides at all-guides.com
JUDO EASY DOS
3.
Product Information
3.1
Intended purpose
This phosphate dosing unit is suitable for
use in cold drinking water up to a water tem-
perature of maximum 30 °C (86 °F).
ATTENTION
(see
chapter
"Safety
dangers due to non-compliance")
Please refer to the chapter on "Intended
Use" for use restrictions.
3.2
Materials used
The materials used are physically, chemi-
cally and corrosively resistant against the
loads that can be expected in the drinking
water und fulfil the DIN EN 13443-1 and DIN
19628 standards ("Mechanically operated
phosphate dosing unit in the water installa-
tion"). All materials are physiologically and
hygienically safe. Metallic materials fulfil the
requirements of the German DIN 50930-6
standard ("Impact on the Drinking Water
Quality"). No electrical cables and devices
may be located underneath or in the imme-
diate vicinity of the phosphate dosing unit!
information
and
Publicité
