Télécharger Imprimer la page

ETQ 3500 Surgge Watts Mode D'emploi page 4

Publicité

Les langues disponibles

Les langues disponibles

Keep the same concept when disconnecting 
electrical devices; make sure all devices are in 
the "OFF" position before disconnecting.  
Operate the generator on level surfaces only. 
Inclined surfaces reduce the effective lubrication 
of the engine.  
Do not expose the generator to excessive 
moisture, dust, dirt, or corrosive vapors.  
NOTICE
 poor treatment of your equipment 
can greatly reduce the life of the LPG generator. 
Use the generator for its intended usage. If you 
have any concerns about maintain your unit 
contact a local service center or called customer 
service (888)‐696‐2345. Operate the LPG 
generator on a level surface and do not place 
objects in the units recoil slots.  
Generator Specifications      
Running Wattage              3000 Watts
Starting Wattage               3500 Watts
AC Load                           
Phase 
T.H.D. 
Weight 
Height 
Width 
Length 
Frequency 
OIL 
Change oil when the engine is warm. Refer to 
the oil specification to select the proper grade of 
oil for your operating environment.
1. Remove the oil drain plug with a 15 mm 
socket and extension. 
 
120V
Single
<5%
102.42 lbs. (46.5kg)
23.31 inches (59.2 
cm) 
16.93 inches (42.0 
cm) 
17.13 inches (43.5 
cm) 
60Hz
 
2. Allow the oil to drain completely. 
3. Replace the drain plug. 
4. Remove oil fill cap/dipstick to add oil. 
5. Add 0.63 qt (0.6 L) of oil and replace oil fill 
cap/dipstick. 
6. Dispose of used oil at an approved waste 
management facility. 
 
 
 
Oil capacity is 0.63 qt (0.6 L).
 
SPARK PLUGS 
1. Remove the spark plug cable from the spark 
plug.  
2. Use the spark plug tool that shipped with 
your generator to remove the plug. 
3. Inspect the electrode on the plug. It must be 
clean and not worn to produce the spark 
required for ignition. 
4. Make certain the spark plug gap is 0.7 ‐ 
0.8mm (0.028 ‐ 0.031 in.). 
5. Refer to the spark plug recommendation 
chart when replacing the plug. 
6. Carefully thread the plug into the engine. 
7. Use the spark plug tool to firmly install the 
plug. 
8. Attach the spark plug wire to the plug. 
Your generator comes equipped with a ¾" long 
reach plug (18 mm) 
Intermittent use (less than 1 hour/month) or 
colder temperatures (below 60°F) 
NGK B4ES or STAR F6TC 
Moderate use (less than 3 hours/month) or 
Seasonal temperatures (50‐80°F) 
NGK B4ES or STAR F6TC 
Extreme use (continuous) or hot climates(80‐
100°F)NGK B4ES or STAR F6TC 
 

Publicité

loading

Ce manuel est également adapté pour:

3000 continuouus watts