Proline DWP5015SA Mode D'emploi page 6

How to fill rinse aid
Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The
dispenser is located on the inside panel of the door .
When the low rinse aid indicator " 1 " is bright ,it means the rinse aid is low,you
must refill the rinse aid dispenser..
1
Low
Full
How to fill the detergent dispenser
Detergent
Detergent specifically intended for use with dishwashers must be used. The
dispenser must be refilled before the start of each wash cycle following the
instructions provided in the "Programme overview". The detergent dispenser is
located on the inside panel of the door.
5
4
Not suitable for the dishwasher
What you should not put into the dishwasher
Cutlery and tableware manufactured in whole or part from wood.They become
faded and unsightly in appearance.Furthermore,the adhesives that are used
are not suitable for the temperature that occur inside the dishwasher.Delicate
decorative glassware and vases,special antique or irreplaceable china. The deco-
rative patterns on such items will not be dishwasher-proof.
Plastic objects that are not resistant to hot water, copper and pewter utensils
are also not suitable. Decorative patterns printed or painted onto the surface of
crockery, glasses, etc.,aluminium and silver items tend to become discoloured
or faded if washed in the diswasher. Some types of glass can become opaque
in appearance after they have been washed many times in a dishwasher. Highly
absorbent materials, such as sponges and towels,should never be placed in the
dishwasher.
Our recommendation
In future, only purchase table or kitchenware that has been confirmed as being
dishwasher-proof.
4
All manuals and user guides at all-guides.com
2
3
7
6
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your appliance, you
must proceed as indicated below when loading the rinse aid.
To open the dispenser, turn the "2" cap in an anti-clockwise direction and then
pour in the rinse aid, making sure not to overfill. The amount of rinse aid used
for each cycle can be regulated by turning the " 3" dose adjustor, located be-
neath the "2" cap, with a screwdriver. There are 6 different settings; the normal
dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting
occurs, the dosage adjustor should be turned to a
higher setting.
If the dishes have white streaks, turn the dosage ad-
justor to a lower setting.
Loading the detergent
To open the " 4 " cover on the dispenser, press the " 5 " button.
The detergent for the wash cycle should be poured into the " 6 " compartment.
The detergent for the pre-wash cycle should be poured into the " 7 "
compartment.
After the detergent has been placed in the dispenser, close the cover and
press down until it clicks in place.
Notice:
To facilitate closing the cover, remove any ex-
cess detergent on the edges of the dispenser.
Damage to glassware and other dishes
Possible causes
type of glass or manufacturing process
chemical composition of detergent
water temperature and duration of dishwasher programme.
Suggested remedy
Use glassware or porcelain dishes that have been marked 'dishwasher-proof'
by the manufacture.Use a mild detergent that is described as 'kind to dishes'.
If necessary, seek further information from detergent manufacturers.
Select a programme with a low temperature and a short duration as possible.
To prevent damage, take glass and cutlery out of the dishwasher as soon as
possible after the programme has ended.
Important
Dishes or cutlery that have been soiled by tobacco
ash, wax, Iubricating grease or paint, should not
be put in the dishwasher.
EN