Publicité
Les langues disponibles
Les langues disponibles
GB
All manuals and user guides at all-guides.com
Troubleshooting
Problem
Possible cause
Solution
Mains circuit breaker operated or fuse blown
Check circuit is capable of required current then reset mains circuit
No power
Internal fuse blown
Have fuse replaced by a qualified electrician
During use the welder stops
Duty cycle exceeded and Over-Heat Indicator (7) is
Leave the welder for 20-30 minutes to cool down
working
illuminated
Incorrect current setting
Adjust Current Knob (4)
Wrong electrode rod/stick
Replace electrode rod/stick
Poor weld
Check Earth Clamp (6). Ensure there is no grease, paint or other surface coating
Poor earth connection on workpiece
that would cause a bad electrical connection with the workpiece
8
Publicité
