Evenflo Snugli Mode D'emploi page 4

ASSEMBLING YOUR STROLLER
5
F F o o r r w w a a r r d d F F a a c c i i n n g g
K
L
M
N
K
To remove the seat assembly , pull both locking levers
upward while lifting the seat assembly from the stroller
frame.
4
K
To Install the seat assembly in either forward-facing or
L
rear-facing position, place the seat sockets over the
M
mounting heads . Make sure the seat sockets lock onto
the mounting heads with audible clicks.
Pull upward on the seat assembly to make sure it's locked
securely onto the stroller frame.
R R e e a a r r F F a a c c i i n n g g
K
L
M
N
6
O
P
Q
R
1
A
B
2
F
F
D
E
C
F
D
ASSEMBLING YOUR STROLLER
O
When installing the canopy , make sure the back flap
Q
positioned behind the seat back .
R
Attach the canopy clips to the seat assembly tubes.
Make sure each canopy
R
R
clip is placed over each
S
locating post
R
USING YOUR STROLLER
WARNING
Avoid serious injury from falling or sliding out.
ALWAYS use waist restraint.
A
To open the bumper bar , press the locking button
side of the stroller, and swing the bar outward.
WARNING
Avoid serious injury from falling or sliding out.
ALWAYS use waist restraint.
Place the baby in the seat and bring the crotch panel
D
between the child's legs. Fasten each buckle and pull the straps
to adjust the waist and shoulder restraints (shoulder restraints only
for 5 point) for a snug, comfortable fit.
E
Note: To loosen straps, push in the release button
and pull up.
Once the child is properly restrained, close and lock the bumper bar.
To change from 5-point to 3-point harness:
F
Remove each harness strap from each buckle
as shown. Remove both harness straps from stroller
seat back. Store shoulder harness straps for future
use.
P
is
S
.
B
, on either
C
up
on the buckle
D
,
5