Indesit CAA 55 Mode D'emploi page 13

DOOR REVERSAL
Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated
containers whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original
packaging).
Remove the doors
1. Lay down the appliance on its back.
2. Unscrew, remove and retain
the bottom hinge.
3. Slightly open the bottom door
and slide downward remove
and carefully place to one
side
4. Remove centre hinge and
spacer if fitted. Slightly
open the top door and slide
downwards, remove and
carefully place to one side.
5.The pin will be removed and
fixed to the opposite side.
6. Use a thin blunt instrument to
remove the top and bottom
hinge bushes and blanking
plugs from the doors, take
care not to mark the door
handle. Reposition the
blanking plugs and bushes on
the opposite side.
7. Fit the blanking plugs provided into the right hand two centre hinge holes
8. Before changing hinge place from right side to left side, screw on left side panel should be disassemblied and
after changing hinge place, screw should be assemblied on right side panel..
Replacing the doors
1. Slide the top door upwards and locate the top hinge pin into the door bush. Reposition the centre hinge on the
opposite side.
2. Carefully slide bottom door
upward into the centre hinge pin.
3. Unscrew the bottom hinge pin and
refit it on the opposite side..
4. Fit the bottom hinge making sure
that the door is aligned to the
cabinet.
5. Carefully stand the appliance
upright in it's required location
and make sure it is sitting level
on the floor. Open and close the
doors checking that the gasket
makes a good seal without any
gaps when the doors are closed.
Note: Replace loose items/fittings
back into the appliance and leave
for at least 15 minutes before
switching back on.
GB
13